Now take the moleskin that fits on the top part of
the ear. Take the tape
off of it completely and spray. Remember, let the glue stand for
approximately 45 seconds before placing the moleskin onto the ear.
Step 22
Click on Picture for Full Size Photo
Now place the moleskin to the top of the ear like so.
Remember; don’t
forget to put a 1/3 inch gap between the moleskin. You do NOT want
mole skin where your fold is going to be. Also, try not to pull any of
those
little hairs, it’s painful. Firmly press the moleskin onto the ear for
about 15 seconds.
Step 23
Click on Picture for Full Size Photo
It should look similar to this when you are done.
Step 24
Now put a dab of Speed-Sew onto the center portion of
the top moleskin.
Step 25
Click on Picture for Full Size Photo
This much is sufficient.
Step 26
Click on Picture for Full Size Photo
Now fold the ear into place. Remember that little
bump? Place the very tip
of the ear to the inside of that little bump or just above it and press
and
hold the ear firmly for about 25 seconds. Let go and the ear should not
come up, if it does, no biggie, just add another dab of Speed-Sew onto
the top portion of the moleskin and repeat this process.
Step 27
Click on Picture for Full Size Photo
Your ear should look similar to this when it’s done.
Step 28
It’s time for the other ear; I will not go into too
much detail because the
process is the same for this ear as it was the last ear.
Step 29
After you spray the mole skin with the 3M Super 77, firmly hold the
moleskin on the ear for approximately 25 seconds.
Step 30
Glue the top portion of the moleskin onto the ear.
Don’t forget about the
1/3 inch gap between the moleskin and make sure the moleskin is not in
your fold.
